Filters
Question type

Study Flashcards

Describe an overhead valve engine.

Correct Answer

verifed

verified

In an OHV engine the camshaft ...

View Answer

Identify four types of fuel currently used in automotive engines.

Correct Answer

verifed

verified

Gasoline, natural ga...

View Answer

The flywheel stores some of the power produced by the engine during the power stroke to keep the pistons in motion during the exhaust, intake, and compression strokes.

Correct Answer

verifed

verified

The largest part of the engine is the ____________________.

Correct Answer

verifed

verified

cylinder (engine) bl...

View Answer

A cylinder leakage test measures the amount of leakage in the cylinder in ____________________.

Correct Answer

verifed

verified

What type of ICE engine listed below is commonly found in a hybrid vehicle.


A) two-stroke
B) rotary
C) diesel
D) Atkinson

Correct Answer

verifed

verified

Which V-type engine valve train design may use four camshafts?


A) OHC
B) DOHC
C) OHV
D) DOHV

Correct Answer

verifed

verified

Diesel engines are being discussed. Technician A says diesel engines have a distributor-type injection pump. Technician B says diesel engines have a common fuel rail and the injectors are controlled by the computer. Who is correct?


A) A only
B) B only
C) both A and B
D) neither A nor B

Correct Answer

verifed

verified

A wet compression test is performed on an engine after a dry compression test revealed low compression on one cylinder. If the compression on the low cylinder rises, it indicates _____.


A) leaking valves
B) worn rings
C) worn camshaft lobe
D) all answers are correct

Correct Answer

verifed

verified

Two technicians are discussing diesel engines. Technician A says all diesel engines are fuel injected. Technician B says glow plugs help ignite the fuel when the engine is cold. Who is correct?


A) A only
B) B only
C) both A and B
D) neither A nor B

Correct Answer

verifed

verified

C

Both valves are closed on the _____ strokes.


A) power and exhaust
B) intake and exhaust
C) intake and compression
D) compression and power

Correct Answer

verifed

verified

Engine oil pressure testing is being discussed. Technician A says that oil pressure should be tested with the engine cold. Technician B says oil with viscosity that is too high may cause lower than specified pressure. Who is correct?


A) A only
B) B only
C) both A and B
D) neither A nor B

Correct Answer

verifed

verified

D

A ____________________ test is used to detect if all the cylinders are producing the same amount of power

Correct Answer

verifed

verified

cylinder p...

View Answer

The rotary engine is also known as a(n) ____________________ engine.

Correct Answer

verifed

verified

The camshaft can be located either in the cylinder block or in the cylinder head.

Correct Answer

verifed

verified

Technician A says weak valve springs can be detected with a vacuum test. Technician B says a restricted exhaust can be detected with a vacuum test. Who is correct?


A) A only
B) B only
C) both A and B
D) neither A nor B

Correct Answer

verifed

verified

C

Two technicians are discussing compression testing on a hybrid vehicle equipped with an Atkinson cycle engine. Technician A says the compression reading of an Atkinson cycle engine is normally higher than a conventional engine. Technician B says a scan tool may be needed to perform the compression test. Who is correct?


A) A only
B) B only
C) both A and B
D) neither A nor B

Correct Answer

verifed

verified

Describe a mid-engine transverse engine layout.

Correct Answer

verifed

verified

In a mid-engine transverse layout the en...

View Answer

Engine torque always increases with engine rpm.

Correct Answer

verifed

verified

Nearly all engines rotate clockwise (as seen from the flywheel end).

Correct Answer

verifed

verified

Showing 1 - 20 of 60

Related Exams

Show Answer